1) For optimum adhesion and durability, reflective tapes should be applied when the temperature is between 10°-38°C. If the temperature is above 38°C, take care to avoid pre-adhesion. If the temperature is below 10°C, heat the application surface using portable heaters or heat lamps, and store the markings in a hotbox to keep them above 10°C.
2) Surfaces to which the material will be applied must be thoroughly cleaned from dust, grease or any contamination which could affect the adhesion of the material. Freshly lacquered or painted surfaces should be completely cured. The compatibility of selected lacquers and paints should be tested by the user, prior to application of the material. The selfadhesive reflective material can only be used for dry application.
3) Remove the liner and position the reflective tape on the application surface.
Tack down lightly to hold the reflective tape in position.
Use your hand to press the reflective tape onto the application surface, and press the reflective tape down using firm, overlapping strokes.
4) If there are hinges, latches or other hardware, cut the tape about ⅛ inches back to avoid buckling.
To apply over rivets, apply the reflective tape over the rivet using firm pressure. Leave a bridge over the rivet head. Use a rivet punch to cut the tape around the rivet. Remove the tape over the rivet head. Squeegee around the rivet.
